Hey Joel, do you (or better yet, someone in Canada...) want to sell one of those 5 DSP set's you have configured and ready to go? If the loopback test can't tell us for sure that the hardware is OK, then maybe I have no choice except to buy a known good one to try... On 9/5/02 12:18 PM, USR-TC@MAILMAN.XMISSION.COM wrote to SUPPORT: -> That's not a test, it's a condition. Yellow means there is a loopback -> condition. So far all posts look correct regarding DNIS. If the Telco sends -> digits, set it to DNIS, and DTMF tones equal to the number of digits. If -> they are not, set it to "no address". This of course assumes your ARC OWNS -> the DSP. Do a List chassis" and make sure your ARC owns the DSP's in -> question. Then, do a "list Int" and makes sure your modem ports say up and -> up. If they are, then more than likely, this is a DNIS digit thing. -> -> Rick -> Team Solunet -> -> -----Original Message----- -> From: Support [mailto:support@inet2000.com] -> Sent: Thursday, September 05, 2002 11:06 AM -> To: usr-tc@mailman.xmission.com -> Subject: Re: [USR-TC] HELP: Lightning HiPerDSP -> -> -> It just stays Yellow forever? It would be nice if it blinked -> a couple times and then went off or something for a -> successful test. Mine goes Yellow no matter what I set -> it to pretty much, and it stays that way forever. -> -> ----- Original Message ----- -> From: "Lewis Bergman" <lbergman@abi.tconline.net> -> To: <usr-tc@mailman.xmission.com> -> Sent: Thursday, September 05, 2002 7:24 AM -> Subject: Re: [USR-TC] HELP: Lightning HiPerDSP -> -> -> > On Thursday 05 September 2002 12:04 am, Support wrote: -> > > Hi Lewis. I tried this with a LoopBack adapter that came with our -> Equinox -> > > Digital Modem Pools we used to have. When I initiate the Loopback test -> by -> > > setting the mode from NoLoop to Payload or Line, the LoopBack LED goes -> > > Yellow (test in progress) but it never comes back from yellow. Can you -> > > explain -> > > how the sequence should look? -> > That's what mine does when I put it on line loopback and put my adapter -> in. I -> > would have to go dig in the docs to see what a bad one does. -> > Try this page for some more troublrshooting help. -> > -- -> > Lewis Bergman -> > Texas Communications -> > 4309 Maple St. -> > Abilene, TX 79602-8044 -> > 915-695-6962 ext 115 -> > -> > _______________________________________________ -> > USR-TC mailing list -> > USR-TC@mailman.xmission.com -> > http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc -> > -> -> -> _______________________________________________ -> USR-TC mailing list -> USR-TC@mailman.xmission.com -> http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc -> -> _______________________________________________ -> USR-TC mailing list -> USR-TC@mailman.xmission.com -> http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc