The reason you're not getting a "Start" in your RADIUS is simple. The Ascend is not accepting the IP assigned to it by the Netserver/ARC. Enable "NAT" in the Ascend. All should be well then. I've had that problem many times before. Jason -----Original Message----- From: owner-usr-tc@lists.xmission.com [mailto:owner-usr-tc@lists.xmission.com]On Behalf Of vanhalen@coredcs.com Sent: Friday, September 24, 1999 15:00 To: usr-tc@lists.xmission.com Subject: (usr-tc) Ascend Pipeline 50 Hello- For whatever reason, unknown to me, I cannot get an Ascend Pipeline 50 to connect correctly via ISDN. I have other users connecting 100% fine to a Netserver based box running Quads. Most of those users are ISDN. When this user with the Ascend dials in, they never get a Start record in radius accounting. I can see them come across but it never starts and it immediately disconnects them. Anyone have any ideas on what I can change on the Pipeline to get them to work? Since I have everyone running fine on this box except the Ascend, I don't think I need to change anything on the box or at the very least I'm really reluctant to do so. Here are the versions anyway. NMC 5.5.0 Netserver ?? Quad 5.10.9 - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message. - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.