Try changing the setting on the DSP DialTrnkType: loopStart to EAndM Type II At the very least you should configure the DSP to these same settings that worked for you on your other gear. Todd -----Original Message----- From: usr-tc-admin@mailman.xmission.com [mailto:usr-tc-admin@mailman.xmission.com]On Behalf Of support@inet2000.com Sent: Thursday, September 05, 2002 2:04 PM To: usr-tc@mailman.xmission.com Subject: Re: [USR-TC] HELP: Lightning HiPerDSP The other equipment has some differences and some different wording for the settins. It lists.... Line Type : dsx1ESF Coding : dsx1B8ZS RecEqualiz: linkRxEqualizerOff LineBuildOut: t1Pulse0dB fd1: : Ansi-T1-403 Mode: : robbedBit robbedbitprotocal: linkEMImmediateStart MessageOrientedSwitchType: ni1 NFAS InterfaceID: 0 NFAS Primary WAN: 1 Loobackconfig: NoLoop SendCode: SendNoCode So, as far as we can tell, the settins are the same on everything they cross over on... We're just really stumped here. Are there settings in the ARC or NMC that can cause a dead air answer? On 9/5/02 11:57 AM, USR-TC@MAILMAN.XMISSION.COM wrote to SUPPORT: -> -> > We get the same results on two different DSP cards, yet the T1 works on our -> > old backup equipment, so it must be OK. -> Why not get the proper line settings from the old equipment and use those? -> -- -> Lewis Bergman -> Texas Communications -> 4309 Maple St. -> Abilene, TX 79602-8044 -> 915-695-6962 ext 115 -> -> _______________________________________________ -> USR-TC mailing list -> USR-TC@mailman.xmission.com -> http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc