I have a questions and it has been a long time since playing with the Hiper DSPs. Other than using TCM can I plugin to the HiperArc and busy out/put in service the DSPs? I know where to do it with the Dual/PRI card, but have not really done anything with the Hiper DSP card from the command line. Need a little guidance here... I have a T-1/PRi that will take a call and it DROPS IMMEDIAELY! This is a circuit that uses NFAS. The D channel is good because calls are staying connected to the other T-1/PRI Any comments help appreciated! ============================================================================== Phillip Ferraro WorldNet Access, Inc pferraro@wna-linknet.com Onslow County's PREMIER InterNet Service Voice (910) 346-0835 824 Gumbranch Square, Suite Q FAX (910) 455-1933 Jacksonville, Nc 28540-6269 ============================================================================== - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.