In the knowledgebase, article ID 1.0.30010810.2189534 goes into great detail about this: Telnet or console connect to the HiPer ARC as a manage user and follow the steps below: 1. Modify each slot for ownership, card_type, and port density via the "set chassis slot" command. 2. Set chassis slot (x-y) console yes <Enter> (where x and y can equal slot range with HiPer DSP cards installed) 3. Verify correct port creation via the "list interface" command. Slot/mod: ports and Slot/CON:1 ports should now be created. 4. add modem_group <name> interface SLOT:X/CON:1 <Enter> (where X = one eligible slot # in line 2) 5. add network service <name> server_type telnetd socket <unused TCP socket number> data service_type=dialout, auth=off, modem_group="name" <Enter> (where "name" = name in line 4) 6. save all <Enter> Note: Only eligible cards with TCS 3.5 software installed (2.0.19 or better) can be console enabled Note: Multiple modem groups and network services can be created to allow console access to all HiPer DSP cards installed and under HiPer ARC ownership as long as a unique TCP port number exists for each service created in line 5 above. Note: Above setup steps are for an unsupported configuration with TCS 3.5 software versions. Use above for a troubleshooting scenario only and disable the network service when not needed as long term usage may cause intermittent problems. TCs 4.0 compatible software fully supports this feature. Matthew Stainforth || Technical Services Manager || BrunNet Inc.

-----Original Message----- From: Harry_Wang@3com.com [mailto:Harry_Wang@3com.com] Sent: Monday, June 26, 2000 11:08 PM To: usr-tc@lists.xmission.com Subject: (usr-tc) how to remote config HiperDSP through HiperARC

Hi, is it possible to telnet to the HiperARC, then establish a virtual connection to the HiperDSP, then access the HiperDSP's CLI? How to do it?

Thanks in advance

- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.

- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.