When I see cards do this, I just replace 'em. If you need one, gimme a call. Thanks, Joel 712-792-8990 -----Original Message----- From: Mike Dappert [mailto:winco@wincoinet.com] Sent: Monday, September 29, 2003 1:52 PM To: usr-tc@mailman.xmission.com Subject: [USR-TC] HiPer DSP card problems I have a Hiper DSP card, connected to CT1. The card went belly up over the weekend. I pulled it several times today and had it restart. About three times it would start up correctly and run for about ten minutes then reboot and go into alarm state, Red RN/FL and a single yellow light on one of the utilization lights on the bottom. During boot up I had the console card connected and when the card would properly boot up I had several messages on the laptop screen and it finally ended with a prompt wanting the Hiper DSP console password. When I hit enter nothing happens and I can get no response. When the card does not boot up properly I get the same initial boot up messages but do not wind up with a passowrd prompt but rather get the following on the laptop screen: !!----------> SDL2 for the PPC403 <------------!! __ Enter Download Trigger __ Flash Image Has Valid CRC, Loading Image.... Diagnostic Power-Up Failure Manufacturing Info -> 1AAA13M0 Mode/Env -> 1/0 Fault Code -> 0-8-25-1 Expected Data -> f011c4fc Received Data -> f01100fc Text Message -> Address Equals Data Test Failure Info Message -> Second read failed. Hard error indicated. One time the last line read Info Message -> Second read failure. Soft error indicated. Any help would be appreciated. Thanks, Mike _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc