Hello, I have a problem with a dual e1/cas card. Software version 1.3.4, serving two e1/cas lines on R2 protocol. The problem is that after a reboot i loose the following settings from the 'Card configuration' menu: 7 Project Id (switching sometimes from configured value R2 to Q412) 10 Set Companding (swithing from configured 'A-law' to 'modem country code') I've saved the configuration many times to nvram, no use. Is there anything I can do to solve this? It's annoying to have to watch the card on every reboot and correct these settings. Dan -- Dan Borlovan <danb@dnttm.ro> System Administrator, Network Operation Center Dynamic Network Technologies - Timisoara, Romania Telefon: +40-56-204967 FAX: +40-56-220201 - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.