Check the fans...make sure all are spinning. I had a hub status light go red because one fan went belly-up.
Gah!
I've got 6 chassis' with dual ARCs, and HiperNMCs, 14 DSPs in one location. All the latest TCS4.5 code. However, one of the chassis's is giving me a red "hub status" on the NMC. The chassis runs fine, otherwise. I've tried swapping out the NMC, rebooting, firmware upgrades, etc... it stays red. Actually, it goes red a few seconds after the NMC gives a console on the RS232 port.
This is a _real_ basic question. How do I find out what is causing this? I've looked in the TCM and I'm pulling my hair out, as I am stumped.
Any thoughts?
----Steve Stephen Amadei Dandy.NET! CTO Atlantic City, NJ
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc
-- ********************************************************* Michelle M. Mogil, InfoTech Engineer Systems & Operations, Cornell Information Technology 735 Rhodes Hall, Cornell University, Ithaca, NY 14853 vox: (607) 255-0516, fax: (607) 255-8521 email: mmm3@cornell.edu **********************************************