Not too sure...I'll look at this a little closer when I have some more free time. 1 suggestion that everyone should probably do before configuring a new box that may work. Did you delete the configuration before reconfiguring it to make sure any old settings were wiped out? Delete configuration Todd -----Original Message----- From: usr-tc-bounces+berto=core.com@mailman.xmission.com [mailto:usr-tc-bounces+berto=core.com@mailman.xmission.com] On Behalf Of Nick Bright Sent: Tuesday, May 24, 2005 3:08 PM To: usr-tc@mailman.xmission.com Subject: [USR-TC] IP System Host Address not reporting correctly Greetings! I am having a slight problem with a TC1000 chassis I'm trying to put back into service. This chassis was in service about a year ago, and we had no problems with it. I've reconfigured all of the IP interfaces according to the documentation, but in the RADIUS accounting packets the NAS-IP-Address and NAS-Identifier fields are reporting an IP address which is no longer on the system (the IP from when the unit was previously deployed). Upon checking the tech support documents at utstar.custhelp.com I found this: ---- snip ---- Question: How can I set the "IP System Host Address" on a HARC card ? Answer: This parameter is defined by the operating system itself, and it is related to the first IP address that is assigned to an interface on the HARC card, there is no way it can be configured manually. In order for you to change it, it is necessary to disable and remove all the other interfaces but the one that you wish to be assigned as the "IP System Host Address". Once all the interfaces but the one you want are removed, the system will assign it automaticaly. The next step then is to add back the IP addresses you removed to their original interfaces, ans save all the changes. ---- snip ---- This seems to make sense, except I have no other interfaces to remove. Only one IP address is defined (on eth:1), eth:2 is administratively down (and has no addresses assigned). The NMC has an IP, but I think that this is unrelated (it's also completely different from the IP showing up as the IP System host address). I'm not sure where to procede, as I am not an expert with these devices. Anyone have any advice as to what to try to get the correct IP to be reported? Everything works fine on the chassis, except the RADIUS accounting data is reported incorrectly. Any comments, advice, or things to try are appreciated. Some system information that might help: HiperARC Hardware Revision: 21.0.0 HiperARC Software Revision: 5.3.2 NMC Hardware Revision: 3.0 NMC Software Revision: 8.7.3 -- - Nick Bright Terraworld, Inc 888-332-1616 x315 http://home.terraworld.net _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc