I am having the absolute worst time trying to get my HyperDSP cards working in any capacity what-so-ever. Hoping someone from here has seen this or can tell me what to check. First i'm running HyperARC HW Version 19.0.0, with Version 4.1.59 Software. HyperDSP's are HW V 0.49.0, and I have thus far tried both 1.2.5 and 2.0.51 software. Im using PRI's and they both show up as UP and OPERATIONAL. (2) Problems... First of all I cant manage the cards (any of them) with TCM. Running 6.0.23, had the same problem on 5.X TCM as well. What happenes is I select the card, click on configure, click on card level and then click ok. I can get the Hyper DSP/ARC Information item, and all values come in and display fine. However I click on "Routing Method" and it comes up with this: Error Type: No Data Available Parameter: Modem Routing Method Object ID: 1.3.6.1.4.1.429.1.26.1.1.1.2.14000 Same type of message comes up on every query except info. I can communicate with the NMC card just fine (its an older NMC, not a HyperNMC). So I had to go in and USE HARM to program the HyperARC (that works fine btw), and I programmed the DSP's with a terminal. Second Issue (and this is the big one) I have two PRI's, 23B+D, Bell atlantic says everything is fine with both of them. But they refuse to hunt from the first hyperDSP to the second. I plug in the first PRI into either DSP card and it takes calls and works like a charm till it gets to channel 23, where we get a fast busy from then on. Im hoping there is a special "Oh you havemore than one hyperDSP" button that I need to push. anyone know what might cause this? -Scott