Since noone replied to the first request for info on this I take it 1) noneone else IS messing with these settings or 2)noone HAS been messing with these settings or 3) Everyone simply ignored the mail. So I'll ask once again and then leave it alone on this list. A few revisions back, can't remember how far, the dsp code started to allow setting of the transmiter power levels. This was under line interface options, transmitter level (-db), the same as the quads used to have. They also had the same -11db setting as the quads did. I have had better luck with the quads ( and some old analog multitech modems ) by lowering the power level to -13db. It helped two different problems, disconnects and the long training sessions that never would connect. I was about to start changing these levels to -13db when I noticed that 3com has changed the default setting from -11db to -10db in 2.0.51. In all previuos releases they were set at -11db. Anyone out have any input on this? Does anyone know how to get measurements from the ct1s to determine what the correct level should be? Terry Kennedy OlyPen, Inc. - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.