At 11:19 AM 6/8/01 -0400, I wrote:
At 10:03 AM 6/8/01 -0500, Mark E. Levy wrote:
I;ve had this happen a few times. Just reboot the NMC card by sliding it out if the chassis or via the console interface and it will be well again (until next time). Rebooting the NMC won't affect active users sessions.
Simple reboot didn't do it. It did apparently keep some stuff, as evidenced by my custom entry remaining in the hub number/status display, but still won't answer to TCM, etc.
It seems that both the WAN and LAN IP addresses have changed to something in the 192.77.203 range. The NMC's address previously had been 204.171.31.3 in one of my /24's. I'm assuming that this should go in the LAN side. Does the WAN side need an address? Also, do any config changes take effect without saving the config to non-volatile memory, or does any changes need saved to take effect? Thanks, -- Kirk Mitchell-General Manager mitch@keyconn.net Keystone Connect Unlock Your World Altoona, PA 814-941-5000 http://www.keyconn.net - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.