but are you sure.this chasis freezes coz of it is old.:(

I mean it works fine without freezing. I feel the problem is not coz of it is old.(just my thought)

----- Original Message -----

Sent: Monday, August 19, 2002 5:01 AM

Subject: Re: [USR-TC] hub status led red

You have a very old code loaded on the card, and also I guess from the version may be you have a 4 meg version card. This particular hardware was long changed with many hardware and software changes. At this juncture the only solution you have is to write a cron job that will reboot the card every 24 hours

----- Original Message -----

From: Murat Küçük

Sent: Sunday, August 18, 2002 8:14 PM

Subject: [USR-TC] hub status led red

I have a Total Control Access Server. I have a problem with it. Periodically it goes dead. And hub status led gets red.

I cant make telnet connection to it. I just make a cold reboot and it continues working.

The room is not hot. So the TC is not hot also. 2 AC is cooling the room.

Where is the problem.

Regards,

Murat Kucuk

www.ebim.net

U.S. Robotics
Total Control (tm) NETServer Card V.34 V3.3.3
Build date: Nov 27 1996
Build time: 17:06:59

Network Interface Card: Ethernet (24)
Packet Bus Circuit : Standard

Licensed for 60 ports.