brian said...
You have to tell us what versions of code you are running..........
Okay... NMC 6.1.17 ARC 4.1.59-6 DSPs 2.0.81 Quads 6.1.6 <--single-sided quads PRI 3.1.5 Don't think it's got anything to do with code versions, though. Been running the above versions and the same configuration on nine other chassis for months and months and nothing like this happened to the other chassis. Since I relocated the power source, I've had no reports of problems, so I'm going with that theory. Forgot my little circuit tester thingy this morning, darn it.
On Thu, 2 Dec 1999 mmm3@cornell.edu wrote:
I have yet to see this particular problem on the list, so I'm going to throw it out there and see what swims back...
For the past several months, on and off, I have been plagued by a problem where a chassis in a particular spot on my rack suddenly stops taking calls and returns a fast busy signal. I have:
1] Power cycled the chassis <--this works for about 8 hours 2] Replaced all the cards 3] Replaced the chassis 4] Swapped out the chassis with a test chassis 5] Swapped the T1s going into the DSPs 6] Removed *all* the cards except for one DSP, one ARC, one NMC, and two PSUs. 7] Tried rebooting the DSPs.
Firmware is at current levels. At one point, I actually sent the whole chassis back to 3Com and received a brand new one. This morning, I took a look at the performance monitor and saw, under "Reason for Call Termination":
pbReceivedLsWhileLinkUp(55)
Under "Reason for Call Failure", I see:
pbGenericError(46)
Anyone know what the heck is going on? I'm ready to call a priest! Incidentally, is there someplace out there where I can get a "dictionary" of those reason for disconnect messages? I have tried the knowledge base and wound up going 'round in circles. Thanks for any help you can give me.
********************************************************* Michelle M. Mogil Network and Computing Systems 721 Rhodes Hall, Cornell University, Ithaca, NY 14853 vox: (607) 255-0516, fax: (607) 255-8420 email: mmm3@cornell.edu ********************************************** - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.