Hi all, A cheapie little Volt/Ammeter just showed up in the mail. Im looking at it and not quite getting how it gets hooked up. It has 4 wires and a horrible little diagram that looks something like this: - ---------------------------- + ---------------------------- - Load --------------------- +Load --------------------- My setup is probably much like everyone elses, I have the 8 switch panel fed from the positive of the battery, and also a little negative bus bar for all the negative wires connected to the negative of the battery Im thinking the simple + and - wires just go to the battery to power the unit. The other two wires that go to the "Load" is where Im losing it... Do I put the +Load on the last position of the switch panel and the - Load wire on the bus? I dunno...Not sure where it would pick up the "load". Hellllp! Thank you all in advance, Im sure I'll have an answer shortly from one of you super geniuses! Here's the item .. http://www.ebay.com/itm/DC-Battery-6-5-100V-20A-LCD-Voltage-Current-KWh-Watt... -= Jazzy