FYI Mboaters - this boat has a STICKER as a cove stripe ... using a scraper, any type, or a heat gun to _remove_ anything stuck to the cove stripe will likely cause damage. BOB needs to provide suggestion as Bob knows the type of 'sticker' used as the cove stripe and its properties and ways to minimize damage when removing the current registration and name lettering. :: Dave Scobie :: M17 #375 SWEET PEA - https://m17-375.com/ <http://www.m17-375.webs.com> :: Truck camper - https://truckpopupcamper.wordpress.com/ :: Ramblings - https://scoobsramblings.wordpress.com/ :: former M15 owner #288 - http://www.freewebs.com/m15-name-scred On Tue, Mar 27, 2018 at 12:19 PM, Charlie Fortner <charlie@rentrof.net> wrote:
On Tue, Mar 27, 2018, at 14:07, Burton Lowry wrote:
I've gotten off a lot of old vinyl lettering by heating them gently with a heat gun. Once they are warm--they don't need to be hot, be very careful and get a razor blade under an edge.
I've had good success with a heat gun, too.
I like to use the plastic scraper blades in my razor holder. Like this: https://scraperite.com/plastic-blades-guide/use
I'm less likely to screw up the underlying surface with a plastic blade.
Charlie
-- Charlie Fortner M-15 #411 Earth, USA, GA, Atlanta